Let's continue with the noise section. First add resistors. Do not pay attention of resistors type on the picture you certainly have different resistors.
Add film capacitors
Add electrolytics capacitors. Electrolytics capacitors are polarized, the long leg of the capacitors is the positive. Pay attention to orientation in which you solder electrolytics capacitors. The black part on the silkscreened electrolytic capacitor symbol is negative.
RPxx resistors are power resistors. You can use a components leg or a 0ohm resistor which acts as a fuse.
Add diodes. Diodes are polarized, the black ring must match the symbol silkscreened on the PCB.
Now, plug power supply and check noise section voltage. Power symbol are silkscreened on the bottom for each ICs. (a square is +15V and a round is -15V).
Unplug your PSU and add ICs. Do not overheat ICs pins during solder process !
Finally, plug your PSU and test Noise out with a Headphone, scope or speakers on IC33 pin 9. Then noise section is finished, let's go to the bassdrum section Booooommmm :)
Follow us