Page 2 of 10
Re: MUX_SH board mod tutorial
Posted: Nov 19th, '17, 04:27
by KlangGenerator
peskado wrote:Thank you for your answer!
where i can find list?
KlangGenerator wrote:lukep_gdansk wrote:KlangGenerator - I sell build one.
Some ppl have second hand Navas also.
lp
Ok, sorry for the misinterpretation, but from your post it was not clear that you are offering built ones. And peskado very much likely built his own Nava and will therefore get the boards for free from e-licktronic.
For unexperienced users with second hand machines it could still be pretty tricky to install the new MUX_SH boards, as they require desoldering the old ICs and fitting new sockets into the pads.
The link was posted in this thread
http://e-licktronic.com/forum/viewtopic.php?f=24&t=1507
Direkt link to the sheet:
https://docs.google.com/spreadsheets/d/ ... edit#gid=0
Re: MUX_SH board mod tutorial
Posted: Dec 13th, '17, 14:51
by Komprezzor
Im very sorry to ask but is there a BOM for the components I need to buy? or a list of the stuff in order to solder ti the mux board?
Re: MUX_SH board mod tutorial
Posted: Dec 17th, '17, 22:13
by druu
Check the specs tab on the shop for that product.
Re: MUX_SH board mod tutorial
Posted: Jan 9th, '18, 21:50
by hofmann25
Has anyone made a mouser cart for this?
Re: MUX_SH board mod tutorial
Posted: Jan 10th, '18, 00:47
by hofmann25
Ok so I've made a mouser cart for these Mux Boards.
Can someone who has built these and successfully done this mod check this cart and correct me if I'm wrong?
https://www.mouser.com/ProjectManager/P ... 83975da3f7
Cheers
Re: MUX_SH board mod tutorial
Posted: Jan 10th, '18, 10:02
by druu
Looks fine mate, though you've doubled up on the 4051's?
Re: MUX_SH board mod tutorial
Posted: Jan 10th, '18, 22:33
by hofmann25
druu wrote:
Looks fine mate, though you've doubled up on the 4051's?
Thanks druu!
Which one. This?
https://au.mouser.com/ProductDetail/511-HCF4051YM013TR
OR
https://au.mouser.com/ProductDetail/595-SN74LV4051AD
Cheers
Re: MUX_SH board mod tutorial
Posted: Jan 11th, '18, 01:53
by druu
I’d go for the ST.
Re: MUX_SH board mod tutorial
Posted: Jan 19th, '18, 11:24
by heapish
Can this be added to a v1.01a board while building, instead of modifying afterwards? That way nothing needs desoldering?
Re: MUX_SH board mod tutorial
Posted: Feb 19th, '18, 14:04
by Dr.Knob
TL074CDT from mouser, no point or nick indicating polarity ...
does anyone know the orientation?
