e-licktronic Forum

Kazper

There is something wrong and a scope would help figure it out.. The audio software scopes are probably far better than picking up something from the vintage test gear market. It might be worth the small price to put the cables together. Where you located? I'm just north of Seattle in the US so if yo...

Kazper

Looking at the schematics, I noticed a few envelope capacitors specified as Tantalum. In striving to be closer to the original circuits and at the request of another member I've put this list together and shared a mouser cart for the parts. Here is a cart link to the Tantalum Caps I put together. Ad...

Kazper

The 4069 should have +/-15V on pins 7 & 14 check with one lead on ground... You also need RP3 (+15v) & RP4 (-15v) filled with lead shorts or 0 ohm resistors. All the RP resistors act as a power rail jumpers.

Kazper

Yes, I tried to do it, but I'm not nearly close to 2v p-p since the sound is so quiet. Regarding this, I have a question: line input is often limited to +- 0.7V (i read somewhere). So how would I be able to measure 2V with a soundcard oscillo? follow his instructions, you need a few parts that shou...

Kazper

beeb wrote:Another question: if I wanted to buy new M5218's to replace potential faulty ones, can I buy M5218 AL ? The ones we got says M5218L (not AL)

Should be same via NTE cross check. All data sheets I find are AL.

Kazper

Did you do this?

http://www.e-licktronic.com/en/content/ ... e-finished

DIY Soundcard scope Probe's
http://www.ladyada.net/library/equipt/d ... probe.html
http://www.instructables.com/id/0-to-50 ... es-Cost-P/

Kazper

Most of the Europen nations are on holiday, so it's probably a while before sub par cases can get fixed or new cases made. Just speculation but I'm going to expect at least a 3-4 weeks, more like 8-10 weeks. I would also point out there is a bunch of money in limbo with the sub par cases.. I don't k...

Kazper

to remove the two 22k, does that mean to remove them and bridge with a component leg or just remove them? just to be safe. You can remove them or Q82 & Q8. As it was said before these just initiate the Q82 & Q83 transistors for a mute circuit. I would measure the line side of D194 and make ...

Kazper

I would reference the schematics and see what makes the most sense. I don't remember what I put in mine. The only difference is I have some high end caps in my outputs and I've use tants in there original spots.

Kazper

Often with DIY it's either bad soldering joint or wrong/falty components. I would look over the sections and check for error in your parts or the construction. Check against the schematics and highlight what has been checked, work one direction toward the other. Don't jump arround if you can help. Y...

Search found 62 matches

Re: Very low / noisy HandClap

Alternative Capacitors "Tantalum" in Bass & Tom Circuits

Re: Snaredrum Power Voltages

Re: Very low / noisy HandClap

Re: Very low / noisy HandClap

Re: Very low / noisy HandClap

Re: Nava v1.0 metal Box [WAITING LIST]

Re: Mix Out Noisy/Distorted

Re: C48 Film or Ceramic? R694 220 ohm or 1.2k?

Re: Very low / noisy HandClap