Page 1 of 1
BD sounds just as a click?! *SOLVED
Posted: Aug 20th, '16, 10:01
by rkzr
Anyone has this problem too? It just sounds like a clicky noise.
Re: BD sounds just as a click?!
Posted: Aug 26th, '16, 16:04
by Kazper
Well I would assume you twisted the knobs etc?
Best thing is to look through ever component and make sure it's correct, then check for solder and solder bridges...
Re: BD sounds just as a click?!
Posted: Aug 26th, '16, 17:10
by rkzr
Hej Kazper, yes twisted the knobs. Next step check all resistors. Already soldered every resistor again on both sides of the PCB to be sure...
Re: BD sounds just as a click?!
Posted: Aug 27th, '16, 00:41
by Kazper
Check the caps and pots if you can..
A misplaced cap can distroy the sound very easy.
How are you triggering it for the sequencer or from the trigger point?
Personaly I think the sequencer should be the second step in the build, so you can trigger your sounds etc.. It makes it easy to set up a easy pattern to look at the outcome via a scope.
Re: BD sounds just as a click?! *SOLVED
Posted: Sep 1st, '16, 08:56
by rkzr
*SOLVED - replaced 1 resistor which was showing weird readings + 1 new capacitor in BD section + replaced 1 capacitor (C31) in NOISE section! BD sounds like a boooooom!