Where are the calibration instructions?
-
There is nothing that I can find in the build docs or manual. I've been going off the 808 service manual but seems odd that they are not here (or I cant find them easily) especially since there are no labeled test points on the yotco
Also, not a single trimmer on my latest build is in range of the correct values. The build docs should be updated with the correct series resistors or at least a note indicating that part may need changing since those parts are difficult to get at
I had to read this forum very throughly to find the info required to calibrate my Yocto.
I had to change a resistor is the noise circuit and solder resistor in parallel with another in the cowbell oscillator section. I can't remeber which ones I changed and the values off the top of my head but can find out if you are interested.
I had to change a resistor is the noise circuit and solder resistor in parallel with another in the cowbell oscillator section. I can't remeber which ones I changed and the values off the top of my head but can find out if you are interested.
Oh I know, this is my second one and I had to do the same thing on the 1st one that I built
What are you referring to? The 4 trimpot calibration settings are all in the build guide? Cowbell usually needs a resistor mod to ge a high enough pitch. What else do you need?
where? I could not find anythingbrock0791 wrote:What are you referring to? The 4 trimpot calibration settings are all in the build guide? Cowbell usually needs a resistor mod to ge a high enough pitch. What else do you need?
The build guide? It's on this page http://www.e-licktronic.com/en/content/ ... one-tr-808
Scroll down half way to the section where it says "Assembly, we recommend that.."
TM1 and TM2: http://www.e-licktronic.com/en/content/34-cymbal
TM4 http://www.e-licktronic.com/en/content/36-noise
Scroll down half way to the section where it says "Assembly, we recommend that.."
TM1 and TM2: http://www.e-licktronic.com/en/content/34-cymbal
TM4 http://www.e-licktronic.com/en/content/36-noise
hm. So they are.
Dont know how I missed those. Thanks for the pointer..
Dont know how I missed those. Thanks for the pointer..
So you built 2 yoctos without the build guide?Altitude wrote:hm. So they are.
Dont know how I missed those. Thanks for the pointer..
Get the latest unofficial Yocto V1 firmware here.
Be sure to check the revised manual.
Leave your comments in this thread.
Be sure to check the revised manual.
Leave your comments in this thread.
never scrolled past the BOM