Page 1 of 1
Yocto finished but no noise
Posted: Aug 3rd, '15, 20:23
by jonnem
Hi everybody!
Finished my Yocto the other night and Everything works as it should exept that the snare has no noise.
Where should i begin searching for any errors made?
Thanks in advance!
/J
Re: Yocto finished but no noise
Posted: Aug 4th, '15, 22:28
by ElSchtroumpf
If only the snare doesn't get any noise, check the few components that connect the noise and snare sections - I don't have access to the schematics, so excuse the vagueness - as well as the Snappy pot.
Also check this thread :
viewtopic.php?f=16&t=213
Re: Yocto finished but no noise
Posted: Aug 5th, '15, 10:56
by jonnem
ElSchtroumpf wrote:If only the snare doesn't get any noise, check the few components that connect the noise and snare sections - I don't have access to the schematics, so excuse the vagueness - as well as the Snappy pot.
Also check this thread :
viewtopic.php?f=16&t=213
Thanks for the replay ElSchtroumpf.
I have desoldered Q48 and it seems ok so i soldered it back on the pcb. I have also resoldered the pot and no difference.
I could really use a step by step guidance here since i feel a a bit lost...