output clips when fully cw

lol, it seems like every time a fix one issue another pops up!

So after fixing the low tom due to a bad opamp, I am near completion of the build and everything makes the correct sound. However, when I have the master volume all the way up some sounds start to clip...the toms mostly and mainly when it is a high pitched . This is a new problem that was not there previously. Any yocto/electronics gurus out there have any idea why this would just start up when it wasn't happening previously?

Do you have the same issue on the individual outs?

Yes I get it regardless of the output I use. I have a suspicion it has something to do with the accent because when I turn it down it goes away. Come to think of it though, I can also make it go away if I back off the master as well. ???