e-licktronic Forum

Hey world !
I'm trying to get the noise section done and i wonder if its bad if i have a solder bridge on the r129 and the pin of u24 that is really close to r129. I have broke my good iron and have to use the cheap one and it's hard for me to get these two solders well separated... Thanks!

Don't worry, r129 is connected with pin 2 of U24.
You might want to have a look at the schematics.

You Sir need a solder sucker!

I can't get along with the sucker... I'm a desoldering braid guy!
Thanks for the advices anyways! I guess i need to learn how to read shematics then .