And another Yocto is born (With internal power supply)
Posted: Sep 17th, '14, 17:58
Hi All,
I would just like to share my finished Yocto.
It has been an on and off built in the past three months and I think it took me about 25 hours to complete. I didn't run into any major issues, other than to change some resistor values to get the correct values and I had to change my 4011BE to a 4011UB.
And it worked flawless ever since.
This weekend I had the pleasure to collect my housing which was one of the ElSchtroumpf group buy. And to meet ElSchtroumpf in person;
Again KUDOS to him for a well managed project!!
In the case I have added a toroidal transformer and although I was a bit reluctant with all these AC wires close to the PCB's, it turned out ok and without hum.
Let the pictures speak for themselves:
I would just like to share my finished Yocto.
It has been an on and off built in the past three months and I think it took me about 25 hours to complete. I didn't run into any major issues, other than to change some resistor values to get the correct values and I had to change my 4011BE to a 4011UB.
And it worked flawless ever since.
This weekend I had the pleasure to collect my housing which was one of the ElSchtroumpf group buy. And to meet ElSchtroumpf in person;
Again KUDOS to him for a well managed project!!
In the case I have added a toroidal transformer and although I was a bit reluctant with all these AC wires close to the PCB's, it turned out ok and without hum.
Let the pictures speak for themselves:
-
IMG_20140913_160144.jpg (201.02 KiB)This goes... Viewed 8241 times
-
IMG_20140913_160154.jpg (253.95 KiB)..into this Viewed 8241 times
-
IMG_20140917_180247.jpg (216.17 KiB)Toroidal transformer. It's a 2x 8V 1.25A, secondaries put in series to get +-16.5V Viewed 8242 times
