e-licktronic Forum

Hello ,

I recently acquired a Yocto and unfortunately, there's a problem with the Roll function. I updated the firmware to v1.2C, but it didn't change anything! I get the sounds, but the tempo doesn't do anything at all. Does anyone know about this problem? Any idea what the issue might be?

Best regard

snake wrote: ↑
Hello ,

I recently acquired a Yocto and unfortunately, there's a problem with the Roll function. I updated the firmware to v1.2C, but it didn't change anything! I get the sounds, but the tempo doesn't do anything at all. Does anyone know about this problem? Any idea what the issue might be?

Best regard

I’ve seen this behavior on the Yocto before. I’d first check whether the Roll rate is actually being set with the tempo encoder, rather than assuming the firmware update will change it. If the sounds trigger but the timing doesn’t follow tempo, I’d also test it with DIN Sync to rule out a MIDI-sync issue.

e-licktronic Forum

Roll function

Roll function

Re: Roll function