e-licktronic Forum

Hi,

I have a Yocto that I just finished (with a big break of 3 years ).

I have some problem with it.

On first power up and start seq immediately, on ~first Step the voices have a good volume, after, all voices volume is decreased

Bassdrum, Snare, Rimshot, claves, and handclap do not work (bassdrum ans snare have very low volume)

If i turn clockwise accent Knob, all voices volume decreased

I'm search, but is to hard to find, i have a doubt on BA6110, but I don't think this is the source of all problems.

Here are the pictures, if you see a few things : https://photos.app.goo.gl/oKS8EBhXQ4mAnXuz7

I can't find anything yet.

if there is someone who knows how to repair this machine and who could do it, PM me

Thanks.

nobody for help ?

If you have an old kit you may want to swap the IC in the accent section because some that e-lick sent were defekt.

It seems you have a lot of non working voices. For each, inspect firstly for soldering issues (there is a few spots where pads are very close but shouldn't connect..), then ICs/transistors and polarized parts orientations, then parts/values placement.

I can physically help in Switzerland, otherwise it's too complicated.

Thanks . I will test.

I made the noise modification of this site (https://masutopedals.wordpress.com/2016 ... ding-tips/), but the other mods are also to be done or this is just improvements?

There is also this site (https://www.dsl-man.de/display/DSO/Yoct ... ding+tipps) which offers mod / fix, are some of them necessary? (first fix it's ok for me)

ok, after replaced Accent CI and all re-checking, all voice work, but :

Bassdrum have only "Attack sound" (no bass) and decay knob don't work.
The handclap sound is fully saturated, BA6110 burned ?

For the clap, just change the trimmer setting maybe ? If your BA6110 was burned, I think it most likely wouldn't output any sound (but I am no expert).

For the bassdrum:
- if you have sockets, try to swap U12 with another similar IC
- check C43 value and orientation
- check R170, R164, R169, R168 (absolute) values

Easily set up your Capital One card by visiting capitalone.com/activate
capitalone.com/activate provides a secure way to turn on your card.
Your Capital One card must be activated at capitalone.com/activate before use.
Fast, safe, and easy activation starts at capitalone.com/activate
Activate your Capital One card digitally at capitalone.com/activate

capitalone.com/activate is the fastest way to enable your new card.
Use capitalone.com/activate to confirm your Capital One card is ready.
Unlock your Capital One card features at capitalone.com/activate
capitalone.com/activate — Capital One’s secure site where cardholders quickly activate new or replacement credit or debit cards online by signing in and entering card details.
capitalone.com/activate is Capital One’s online card-activation portal for credit and debit cards

capitalone.com/activate is where you validate your Capital One card.
Complete the card setup in minutes at capitalone.com/activate
Secure your Capital One card access by visiting capitalone.com/activate
capitalone.com/activate is the go-to page for Capital One card activation.
Make your Capital One card active and usable at capitalone.com/activate

With capitalone.com/activate , your card can be ready for spending quickly.
Activate your Capital One credit or debit card at capitalone.com/activate
The Capital One activation service is available at capitalone.com/activate
Ensure your Capital One card works properly by visiting capitalone.com/activate
capitalone.com/activate allows you to switch on your card instantly.