e-licktronic Forum

Hi all

My Yocto v1 push encoder suddenly stop working, the tempo still works but not when I push it

I’ve rarely used my yocto since I’ve built it and this function always used to worked properly but maybe after updating firmware that the problem arise ?

Anyone here have this issue?

Just dont feel like changing the pot if it a software problem

Any help is appreciated

Best regards,

rqckmounted wrote:Hi all

My Yocto v1 push encoder suddenly stop working, the tempo still works but not when I push it

I’ve rarely used my yocto since I’ve built it and this function always used to worked properly but maybe after updating firmware that the problem arise ?

Anyone here have this issue?

Just dont feel like changing the pot if it a software problem

Any help is appreciated

Best regards,

Does the encoder button push work if you go back to an earlier firmware version?

No I tryed to go back but it still does’nt work ?

In that case, it doesn't sound like you have a software problem. Check the connections on your encoder. You can try to reflow the solder joints to see if that helps.

Ok thanks for the tip !! I will check it out

thanks for the advice. I'll investigate it.