e-licktronic Forum

hello, so i finished to build my yocto2
the last thing to do is calibration

and my point of view is that is not really easy
i started to calibratate with my ear..

tm1* ok ( with my multimetre)
tm2* ok

not sure with dac calibration: my multimeter not really tell me Always the same value….?

i Don't understand " sequencer in voice test mode" : how do you know you are in voice test mode ?

where is handclap multiout exactly ( i m not sure)

and with noise, when i'm at the minimim, i have 600mv rms ??

thank for your help and answer

in fact, tm1* is not really excat, a have 360hz and 390hz is required

and i'm fully clockwise….

ah ok i think i understand what is voice mode
must i shut 1and 2 where it's writting test mode under the sreen, at the c600 left ?

Just put the jumper there to bridge the first and second pin so all the voices get triggered automatically.