Page 1 of 1
Any Advice for Assembly?
Posted: Aug 28th, '17, 20:46
by ♥♥♥
I recently bought the Yocto2 and I wondered if there is anything I should look out for before I start building? Or is it simply a matter of soldering the correct components in the correct place? Does the advice for the original Yocto here:
https://masutopedals.wordpress.com/2016 ... ding-tips/ still apply? Thanks.
Re: Any Advice for Assembly?
Posted: Aug 29th, '17, 00:13
by blotvard
Another good build blog:
https://tr-bob.tumblr.com/page/2
Some advice I'm using myself:
- Use a decent soldering iron and solder. I'm using Kester '44' Rosin Core.
Wear eye protection and use a fan to vent your workspace.
Get some good quality side snips, a desoldering pump and some braid.
Use a forming tool
Use a heat sink when soldering the transistors.
Get a cheap component tester on Ebay.
Don't use a mains transformer.
Take your time and try not to make any mistakes
Re: Any Advice for Assembly?
Posted: Aug 29th, '17, 14:16
by lalazart
I would say go component by component, value by value. But before start with a new value count to make sure you have the correct amount. It's faster and there are fewer chances you'll make a mistake. If you end up with an extra resistor 47k, you know you made a mistake, but chances are you won't if you're a little bit careful.
Also, be careful when clipping leads. I was clipping too fast and pulled a couple pads.
In the end, I didn't have any problems when I powered it for the first time.
Re: Any Advice for Assembly?
Posted: Aug 30th, '17, 20:13
by ♥♥♥
Thank you both for your replies. It's good to see that there is nothing too specific to this build and its generally just advice. Thanks again.