Page 1 of 2
Nava Bass Drum Pitch
Posted: Feb 13th, '17, 18:23
by Aarrgghh
Remove the R59 resistor from the bass drum section. Connect a 47kohm linear potentiometer together with a 22k resistor (as seen in the picture).
Sample:
https://dl.dropboxusercontent.com/u/363 ... dpitch.wav
Re: Nava Bass Drum Pitch
Posted: Feb 13th, '17, 18:34
by BedroomMusic
Demo pls?
Re: Nava Bass Drum Pitch
Posted: Feb 13th, '17, 18:38
by Aarrgghh
Added a sample wave in the post!
Re: Nava Bass Drum Pitch
Posted: Feb 23rd, '17, 16:07
by KlangGenerator
Aarrgghh wrote:Added a sample wave in the post!
How did you manage to get those thick pots inbetween board and case? There is almost no space...
Re: Nava Bass Drum Pitch
Posted: Feb 24th, '17, 11:08
by Aarrgghh
The pitch pot is mounted on the back of the nava, just above the power switch (I'm using the Erica enclosure)
Re: Nava Bass Drum Pitch
Posted: Feb 24th, '17, 11:48
by KlangGenerator
Aarrgghh wrote:The pitch pot is mounted on the back of the nava, just above the power switch (I'm using the Erica enclosure)
I was wondering because in your videos you have installed all extra pots on the front. I have exactly the same pot shown in your picture above. Without removing a part of the thread it definately won't fit in the gap between board and case.
Re: Nava Bass Drum Pitch
Posted: Feb 24th, '17, 14:39
by KlangGenerator
Re: Nava Bass Drum Pitch
Posted: Feb 24th, '17, 22:59
by Aarrgghh
Hm. I didn't upload any videos of mine. But here's a picture. The one in the back is the pitch. And the one in the front is the dist/drive.
Re: Nava Bass Drum Pitch
Posted: Feb 25th, '17, 08:47
by KlangGenerator
Aarrgghh wrote:Hm. I didn't upload any videos of mine. But here's a picture. The one in the back is the pitch. And the one in the front is the dist/drive.
Oops, I messed something up there...
Don't know why, but I always thought this was you:
https://www.youtube.com/watch?v=JHGBR4sBk1U&t=34s[/video]
Re: Nava Bass Drum Pitch
Posted: Feb 25th, '17, 08:50
by Aarrgghh
Nope!