Nava don´t works, help. Microcontroller problem?
-
Hi Klang. Thankyou very much for your fast reply. Yes I did a reset a couple of times before the ic115 replacement. I´ll do again, and yes I did the tm3 adjustment. I´ll try to load the firmware again via sysex. I´ll let you know what happens
I just tried to initialize the eeprom, it does the init but any change. I loaded again the firmware via midiox, it does the transmission, it load into the nava but no way.
Sequencer not running,no characters on the display only red boxes, any sound... I checked the voltajes again and I am getting 13V instead 15V, before the io pcb it´s 15V, after the I/O I have 13, its normal? maby regulators not workin properly?. Maybe not enought power for running the nava properly?
Thx in advance, I am an expertisser DIYer but I am not electronic, so maybe I missed something important but an electronic friend of me is almost sure than the atmega is dead.
Sequencer not running,no characters on the display only red boxes, any sound... I checked the voltajes again and I am getting 13V instead 15V, before the io pcb it´s 15V, after the I/O I have 13, its normal? maby regulators not workin properly?. Maybe not enought power for running the nava properly?
Thx in advance, I am an expertisser DIYer but I am not electronic, so maybe I missed something important but an electronic friend of me is almost sure than the atmega is dead.