e-licktronic Forum

Hello,

I'm nearly finished building the Yocto, but my VR1* from the kit I purchased at the online store is not the larger-style pot and is instead the smaller style. I think this is a mistake, as the smaller pot does not fit in the PCB.

What is the manufacturer and part number for the correct 50kA pot in the master section?

Thank you and take care!

I have the same issue. The vol pot is the wrong size.

I think the pot is made by BI-Technologies sold at mouser and digikey but I can't find the right value.

http://www.mouser.co.uk/ProductDetail/B ... f7xxjzE%3d

I've send a message to e-licktronic asking if I can get a replacement.

Dear,

the right potentiometer is this one http://eu.mouser.com/ProductDetail/Bour ... p%2fGS8%3d

The Master potentiometer 50KA is out of stock but we have the 100KA that could replace it.
If you need one contact Vincent.

Best regards,
e-licktronic

e-licktronic wrote:Dear,

the right potentiometer is this one http://eu.mouser.com/ProductDetail/Bour ... p%2fGS8%3d

The Master potentiometer 50KA is out of stock but we have the 100KA that could replace it.
If you need one contact Vincent.

Best regards,
e-licktronic

Thank you. I have been in touch with Vincent and he's made things right. Thanks again!