e-licktronic Forum

Hi, on the printed circuit there are CV/gate outputs silkscreened. I have not yet tried to wire CV/gate sockets, anyone tried it is what it works

Salut, Diplo,
Vu que la plupart des gens ont des soucis pour faire fonctionner leur nava sans modification, ça m'étonnerait qu'on trouve un casse-cou dans ton genre capable de faire ça!

When i finished my build, I hooked a scope to the CV/Gate outputs but it seems they can't be used as is, it would need an additional board with a multiplexer and something to adjust the tune. I didn't try to wire jacks cause the CV output is directly coming from the DAC, so even if it worked like that, it would need proper protection like a buffer and diodes. When I was experimenting with the CV output of my x0xb0x, I accidentally sent -15V into the CV out and fortunately there was a little 1N4148 that did its job perfectly by burning and protecting the other part of the circuit.
Did you ask Vincent about that? I'll send him a mail to see how he planned this optionnal board.

(bon je sais j'aurai pu poster en français mais on est pas dans la bonne section ^^)

So, my nava run with mods. But it took patience and perseverance. (I'm in the process of drilling my happyM case)
On the other hand i asked the question about CV / gate outputs, because i also notice that the keypads, there are silkscreened the notes C, C #, D, D and all others. Not seeing anything about it in the assembly manual, hence my questioning.
Would there be an additional PCB later planned? Where at least a schematic? Something?
Where does this interest me and everyone does not care?

Nice, which mods? I only did the 2nd noise source and the +5v to +12V Trig I explained in the mod section. Maybe I'll add tune to the hi hats, can be cool!

The external instrument feature works with MIDI already, but I don't really like how to program melodies and also the fixed length gate, so i don't know if I'll add the CV/Gate output when (if?) it's available. Also maybe because I already have a Beatstep and my x0xb0x to sequence my modular

Off topic:
BD: tune extend, decay extend, pitch mod, drive mod, fuzz FX, noise fuzz FX.
Lt: 2nd fuzz FX, noise fuzz FX.
Rimshot: pitch1, pitch2 and pitch3.
Clap: reverb extend, Hi pass noise filter, time mod, noise increase. (+2nd noise source by altitude)

Everything works andiI can always have the original sound.



Still nobody for CV / gate outputs?

I put a sticker TR909 because i do not know what nava means (only the word within in Kurdish), but at home it is a brand of motorcycle helmet:

Dr.Knob wrote:Hi, on the printed circuit there are CV/gate outputs silkscreened. I have not yet tried to wire CV/gate sockets, anyone tried it is what it works

Dr.Knob,

CV/Gate are not implanted yet in the firmware.
Notes names are used in the Keyboard mode.
Any suggestion on how you want to use this CV/Gate out are welcome

Best regards,
e-licktronic