e-licktronic Forum

Anyone who can point me to the direction of 10k linear bourns-type of-pots, like the ones that where in the kit.
But they have to be a bit thinner, as I would like to place a pot for the hi-hat pitch above the decay pot for short hat. So it have to be above the PCB
I also would like to use the sam pots as ordered within the forum.

If anyone knows anything that might work, it would be nice
But maybe not possible to find..

I'm considering the Bourns PTV09 Series for modifications on my Nava,
specially the ones with the U-Type shaft, since no additinal knobs are needed and still make a decent visual appearance

(same were used for x0xio mod on x0xb0x)



but they have no threaded bushing..

how much is the space between the PCB and the housing btw? (don't have a housing yet)

10mm.