Page 11 of 44
Re: Exploring other enclosure options.
Posted: Apr 8th, '14, 19:19
by ElSchtroumpf
@pOulp, I'm going to try to make a DXF of the face and back cutouts tomorrow. I'll let you know how that works out. If anyone has more experience with AutoCAD, feel free to contact me!
Re: Exploring other enclosure options.
Posted: Apr 8th, '14, 19:42
by p0ulp
Great ! They are expecting a DWG or DXF file, I should also have to figure out how to fix the control board on the back of the front panel, I ll have a closer look at the assembly guide, to see where are supposed to be the hole, on the pcb.
Re: Exploring other enclosure options.
Posted: Apr 8th, '14, 20:46
by 80sboy
Are you going to make another round of enclosures down the road?
I'm still waiting for 4th batch!
tom
Re: Exploring other enclosure options.
Posted: Apr 9th, '14, 00:41
by JakeE
@ ElSchtroumpf okay no problem was just an idea about the switch.
May sounds fine Im In no rush for a case as still waiting on 4th batch + gives time to earn some more money to pay for it all. thanks for all this
Re: Exploring other enclosure options.
Posted: Apr 9th, '14, 01:28
by trshbnk05
@ElSchtroumpf would be interested in one case too if that's a possibility
Re: Exploring other enclosure options.
Posted: Apr 9th, '14, 05:46
by bramsluiter
I have an original 808 and think that the orange dot means something like 0db. Couldn't make anything else of it
Re: Exploring other enclosure options.
Posted: Apr 9th, '14, 07:55
by ElSchtroumpf
I have an apology to make. The reason the price went down from 130 to 100€ per case is because I forgot the offer they sent me did not include VAT in the prices. I am terribly sorry about that.
For the people who would still like an enclosure, send me your details in a PM, I'm still accepting offers. I need your full address, email and whether you need a switch and a C14 connector.
Re: Exploring other enclosure options.
Posted: Apr 9th, '14, 16:24
by ElSchtroumpf
I received a new offer from the factory. With the prototype cost and VAT included, you're looking at 125€ per enclosure. The price for 20 units is quite a bit lower than for 10 units.
This is the price without feet, switch or C14. Packaging and shipping is not included either. As soon as I have found some decent feet I should have a good idea of how much the total cost will be. However, the more units I can order, the less a single unit will cost!
Re: Exploring other enclosure options.
Posted: Apr 10th, '14, 00:21
by trshbnk05
@ElSchtroumpf PM sent
Re: Exploring other enclosure options.
Posted: Apr 10th, '14, 08:50
by ElSchtroumpf
I got a PM that raises a good point : since there will be a prototype, I won't ask for any payment until I can put some pictures online. At that point I would like confirmation of everyone on my list, but I'll probably contact you by email then.