I know this has been discussed very often..
I only get 50mv at PIN1 U24
all resistors are correct in the noise section.. double checked it
I tried everything.. R127 with 47K .. with 4,7K .. adjustable resistor..even if i go under 1k... nothing ;(
where is my fault?
the only what i did diffrently is that i used at C31 a 1/100 instead of 1/50 .. could that be the problem?
maybe a faulty sc828r ? this is what i read here... possible to meassure something at the Q35?
would be thankful for every advice
best
sascha
Wrong Voltage Noise Section
Power supply you are using is Ac or Dc?
The chip might be faulty.SOM wrote:I know this has been discussed very often..
I only get 50mv at PIN1 U24
all resistors are correct in the noise section.. double checked it
I tried everything.. R127 with 47K .. with 4,7K .. adjustable resistor..even if i go under 1k... nothing ;(
where is my fault?
the only what i did diffrently is that i used at C31 a 1/100 instead of 1/50 .. could that be the problem?
maybe a faulty sc828r ? this is what i read here... possible to meassure something at the Q35?
would be thankful for every advice
best
sascha
Are you getting correct voltages everywhere but on that specific chip?