I goofed. Please help

Discuss Yocto construction and related issues
  • onebase wrote:Hello, I managed to plug a 12V dc plug into my yocto for a short period of time and it no longer turns on. I hope the issue is isolated to the psu. :oops:
    Any suggestions on how to start a fix if possible would be greatly appreciated.
    BEST
    ~
    J
    Onebase,

    First check PSU voltage +15v, -15v and +5V

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • e-licktronic wrote:
    onebase wrote:Hello, I managed to plug a 12V dc plug into my yocto for a short period of time and it no longer turns on. I hope the issue is isolated to the psu. :oops:
    Any suggestions on how to start a fix if possible would be greatly appreciated.
    BEST
    ~
    J
    Onebase,

    First check PSU voltage +15v, -15v and +5V

    Best regards,
    e-licktronic
    Thanks for swift response. I am getting all the correct voltages off the psu. :*(
  • onebase,

    Is your sequencer running ?
    is there a burned 100ohm resistor on the PSU bus ?

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • e-licktronic wrote:onebase,

    Is your sequencer running ?
    is there a burned 100ohm resistor on the PSU bus ?

    Best regards,
    e-licktronic
    no lights come on at all. I dont' see any burt resistors... Unless I'm missing it. Which R# is that one?
  • onebase wrote:
    e-licktronic wrote:onebase,

    Is your sequencer running ?
    is there a burned 100ohm resistor on the PSU bus ?

    Best regards,
    e-licktronic
    no lights come on at all. I dont' see any burt resistors... Unless I'm missing it. Which R# is that one?
    Those are the 100 ohm resistors on the top edge side of the main board.
    Is there leds that light up when power on your Yocto ?
    What sequencer mods is selected?

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • e-licktronic wrote:
    onebase wrote:
    e-licktronic wrote:onebase,

    Is your sequencer running ?
    is there a burned 100ohm resistor on the PSU bus ?

    Best regards,
    e-licktronic
    no lights come on at all. I dont' see any burt resistors... Unless I'm missing it. Which R# is that one?
    Those are the 100 ohm resistors on the top edge side of the main board.
    Is there leds that light up when power on your Yocto ?
    What sequencer mods is selected?

    Best regards,
    e-licktronic
    ok the lights came on and it mostly work though the kick and clap are triggering every step of the sequence. when i edit the kick or clap sequence I get a more pronounced hit of the instrument. Turning the volume up has the clap bleeding noise.
  • Question does this issue sound like a busted sequencing chip?