Hello,
I'm nearly finished building the Yocto, but my VR1* from the kit I purchased at the online store is not the larger-style pot and is instead the smaller style. I think this is a mistake, as the smaller pot does not fit in the PCB.
What is the manufacturer and part number for the correct 50kA pot in the master section?
Thank you and take care!
Wrong Master Volume Pot in Latest Yocto Kit
I have the same issue. The vol pot is the wrong size.
I think the pot is made by BI-Technologies sold at mouser and digikey but I can't find the right value.
http://www.mouser.co.uk/ProductDetail/B ... f7xxjzE%3d
I've send a message to e-licktronic asking if I can get a replacement.
http://www.mouser.co.uk/ProductDetail/B ... f7xxjzE%3d
I've send a message to e-licktronic asking if I can get a replacement.
Dear,
the right potentiometer is this one http://eu.mouser.com/ProductDetail/Bour ... p%2fGS8%3d
The Master potentiometer 50KA is out of stock but we have the 100KA that could replace it.
If you need one contact Vincent.
Best regards,
e-licktronic
the right potentiometer is this one http://eu.mouser.com/ProductDetail/Bour ... p%2fGS8%3d
The Master potentiometer 50KA is out of stock but we have the 100KA that could replace it.
If you need one contact Vincent.
Best regards,
e-licktronic
Best regards,
e-licktronic
e-licktronic
Thank you. I have been in touch with Vincent and he's made things right. Thanks again!e-licktronic wrote:Dear,
the right potentiometer is this one http://eu.mouser.com/ProductDetail/Bour ... p%2fGS8%3d
The Master potentiometer 50KA is out of stock but we have the 100KA that could replace it.
If you need one contact Vincent.
Best regards,
e-licktronic