TUTO: How to get a Full Yocto v1.0 Kit

Discuss Yocto construction and related issues
  • I just recieved my BOM from mouser in the mail and unfortunately I just trusted your list without going over it. All the film capacitors are listed as cermamic in your new BOM.
  • Please revise your whole BOM. I just started my build and 5 minutes in aside from the last issue C11 calls for a 220/35 capacitor and the BOM has a 22/35v listed
  • Output jack lead is too wide for the pcb hole.
  • Hi,
    Has the list been changed and is it up-to-date now?
    Thanks.
  • Dear brock0791,

    BOM updated with film capacitors and 220uF/35v electrolytic capacitor.
    1/4 PCB Jack should match the IO Board

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • Thanks. Also the bom has 6.3v instead of 33v aluminium caps for the 25uf... are these on the 5v line and 6.3v is sufficient or was it a mistake?
  • Build requires 29 4k7 resistors. Bom lists 28
  • brock0791 wrote:Thanks. Also the bom has 6.3v instead of 33v aluminium caps for the 25uf... are these on the 5v line and 6.3v is sufficient or was it a mistake?
    33uF 6.3v replace by 33uF 25V
    Build requires 29 4k7 resistors. Bom lists 28
    You only need 28x 4k7 resistors
    Why do you think about 29pcs?

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • Noise: x1
    Accent: x3
    Bassdrum: x2
    Snaredrum: x1
    Lowtom: x5
    Middletom: x4
    Hightom: x4
    Rimshot: x1
    Handclap: x4
    Cowbell: x1
    Cymbal: x1
    Hihats: x2
    Total: 29