I am assembling my Yocto now and am going through the clap section, when randomly one of the 10k resistors is listed as being R200, which is in the snare section and was previously listed as a jumper... there is a jumper installed there now as per the prior instructions. Is this a misprint in the assembly guide? Is this 8th 10k resistor supposed to go somewhere other than R200, or am I supposed to replace the jumper? Or is the R200 just an outright typo and there are only actually supposed to be 7 10k resistors in the clap section?
I am fairly confused right now.
Thanks guys/girls!
Edit, I figured this out after stuffing the rest of the board and looking for missing locations, just in case anyone else gets stuck on this one and does some googling in the future, the R200 in the clap section is actually R200' and if you type it into Eagle as just R200 it shows the snare version, r200 prime will bring up the correct location in the clap section.
Onward to the cowbell ^_^
Hand clap R200 ? Resistor or jumper?
Yeah, it must be a 10K resistor instead of a jumper.
The jumper is supposed to be in the Snare only.