Hand Clap Sound problem

Discuss Yocto construction and related issues
  • Dear Muffy1975,

    What is your C140 value. On the original schematic it's 2.7nF but with this value you didn't get the 30ms pulse.
    You have to change this value to 27nF.
    Try to add a 10k resistor between Q70 emitter and -15v PSU that VCA will open to get clap verb.

    I hope it will help you

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • HI,

    thanks e, thanks for getting back to me.


    i will give this a go!

    Kind regards

    Michael
  • Hey,


    yes i had 2n7 there not 27n. Swapped that out and added the 10k resistor to the emitter of q70. The clap sounds too fast and not deep enough still . I suspect i am not getting all the four pulses. Is there any way of checking this. I have scope!!

    The clap sound is too fast with no enough body. Is there aany way of slowing down the pulses as per eric archer's clap raca??


    Thanks again


    Michael
  • Muffy,

    PM me. I can help you.
  • HI,

    i have pm'd you.

    thanks indeed for any help

    Michael
  • Sorry, Muffy, but it won't let me PM you back (it says I'm too new to the forum??).

    PM me your email address, please.
  • Dear Muffy,

    Maybe you could share your experience on this topic ?

    Best regards,
    e-licktronic
    Best regards,
    e-licktronic
  • So to clarify - If I'm following the directions online and the printing on the PCB will this be correct or not?
  • So to clarify - If I'm following the directions online and the printing on the PCB will this be correct or not?
    What are you talking about?
    Best regards,
    e-licktronic