Sequencer issue (solved)

• JanneI

  Posts 19

  Joined: Jan 26th, '16, 09:14

  Mar 10th, '16, 12:38

  Hi all,
  
  I just finished building Yocto and everything else works as should, but all the leds are on and I think that the "shift" button is on all the time. I swapped IC7 <-> IC8, and it's little different, but still not working. Sometimes with a longer push the "play" button works as a "roll" button, so I'm guessing it's triggering the sequencer on-off-on-off-on-off... Could it be a faulty IC2/7/8? Or some kind of short circuit somewhere? What should I search?
  
  
  Cheers,
  Janne

  Last edited by JanneI on Mar 15th, '16, 17:36, edited 1 time in total.

  • Quote

JanneI

Posts 19

Joined: Jan 26th, '16, 09:14

Mar 10th, '16, 16:51

Thanks! I'll check them, but I'm pretty sure that I have the correct values. BTW, the sequencer works as should, so if the crystal was the problem shouldn't it affect the whole sequencer, timing etc? Because I can even program new patterns, but when I press one of the step buttons to add a step while the sequencer is running, it sets "the last step", which according to manual should be "shift+step1-16"? Also, in init eeprom -mode I only need to press start to start initializing (shouldn't it be start+shift?).

Hope this helps...

edit: Not sure if these FB videos will show correctly but here you can see how start -button works (on-off-on-off-on if pressed longer). I also was able to program that custom pattern with the buttons, even though it changed the "last step" many many irritating times

https://www.facebook.com/IsotaloJanne/v ... 93/?type=3


Cheers,
Janne

• Quote