Hi all
My Yocto v1 push encoder suddenly stop working, the tempo still works but not when I push it
I’ve rarely used my yocto since I’ve built it and this function always used to worked properly but maybe after updating firmware that the problem arise ?
Anyone here have this issue?
Just dont feel like changing the pot if it a software problem
Any help is appreciated
Best regards,
Push encoder suddenly stop working after firmware update ?
Does the encoder button push work if you go back to an earlier firmware version?rqckmounted wrote:Hi all
My Yocto v1 push encoder suddenly stop working, the tempo still works but not when I push it
I’ve rarely used my yocto since I’ve built it and this function always used to worked properly but maybe after updating firmware that the problem arise ?
Anyone here have this issue?
Just dont feel like changing the pot if it a software problem
Any help is appreciated
Best regards,
No I tryed to go back but it still does’nt work ?
In that case, it doesn't sound like you have a software problem. Check the connections on your encoder. You can try to reflow the solder joints to see if that helps.
Ok thanks for the tip !! I will check it out
thanks for the advice. I'll investigate it.