please help, i measure between J10 pin1 and J10 pin8 only 4,92v. Is that a problem? all components are on the right place, ich checked that 200 times.
i get +15.09 and -15.03 that correct. but in the assemby guide is not tolerance for the +5volt rail.
thankx
psu - not the exact voltage
Just try like this. To reach another voltage you may try another regulator.
thank you for the answer.
i will try it. thanks
i will try it. thanks
Hey guys!
What do u mean by « try another regulator »??
Just change the component??
For me -15,+15 are fine but I find 4,9 instead of 5V. What is the headroom for the 5Vrail?
R0ohm = jumper right??
Thx in advance
What do u mean by « try another regulator »??
Just change the component??
For me -15,+15 are fine but I find 4,9 instead of 5V. What is the headroom for the 5Vrail?
R0ohm = jumper right??
Thx in advance
Is there a problem ? Probably 4.9V is fine.