I've stupidly started building the Yocto 2 without following the assembly guide and only now got to testing what I've built.
I've finished the whole IO board, but I'm measuring 18.35v where I should be getting 15v, and I'm only measuring 1.5v between J10 pin1 GND and pin8 5v.
I've checked and double checked my soldering and replaced both REG1 and REG2 but I keep measuring those same voltages.
Can anyone please point me in the right direction in order to start troubleshooting?
Building IO Board - Measuring wrong voltages
You are sure your power supply (adapter) is an AC one?
Min 16V and 1A AC
Min 16V and 1A AC