Software and Hardware

Here we talk about e-licktronic projects (hardware, software) like SquareSeq, Ablickton...

Software and Hardware

Postby scass201 » May 24th, '16, 15:03

I'v acquired the PotMux library and I've been using it alter my output wave form my Arduino and other wave shaping parameters. However, as I adjust pots the signal either craps out on me or it gets stuck in one section. I think it's a matter of a mass amount of noise going through my perf-board from my test hardware but I'm curious if theres anything in the software that could cause these issues?
scass201
 
Posts: 2
Joined: May 24th, '16, 14:56

Re: Software and Hardware

Postby Janis » Mar 1st, '17, 06:55

Computer hardware is any physical device used in or with your machine, whereas software is a collection of code installed onto your computer's hard drive. A completely extremely good weblog put up. We’re in truth grateful to your blog publish. You’ll locate some of strategies after traveling you’re placed up. I was exactly looking for. Thank you for such submits and please preserves it up
Janis
 
Posts: 1
Joined: Mar 1st, '17, 06:52

Re: Software and Hardware

Postby morandsa » Aug 19th, '19, 08:34

You can find more here

https://www.allicdata.com/
morandsa
 
Posts: 1
Joined: Aug 19th, '19, 08:29


Return to Projects

Who is online

Users browsing this forum: No registered users and 1 guest