Current Yocto2 OS in HEX

  • Here it is with Vincent's permission: Yocto_v2_002.hex

    I used a TL866 programmer with the following settings:

    Fuse Low Byte: 0xD6
    Fuse High Byte: 0xDC
    Extended Fuse Byte: 0xFD
    Lock Bit Byte: 0xFF
  • Do you need to load the bootloader first on the chip? Can you use the Yocto v1 bootloader for this?
  • No need, I just flashed a new chip with the programmer.
  • blotvard wrote:No need, I just flashed a new chip with the programmer.
    Hello!
    I have same problem
    What software are you used for burn chip?