e-licktronic Forum

Hi there!
this is my first built, and here is where i am....

I built IO board, sequencer parts for auto trigger, and noise

I know there is a few topics on that subject, but my problem adds a bit of it all (i think)

As i saw on the topic "Cannot adjust TP1 to 5V : stays around -0.2V [SOLVED]" by tupinamba, i checked voltages at all square pads and i get the normal +5v
but at TP1, i get at most 0.6v (most of the times, its around 0.3)

and then, weird thing (maybe some of you will be able to tell me whats that) when i tried to set up TP4 at 130mV, i get a maximum of 70mV which is slowly decreasing if i keep probing that point, untill all power is gone

Maybe this can ring some bells with people that know their business (i hope!)

Any help would be greatly appreciated as i triple checked all components orientation...

Ok so apparently i wanted to jump many steps by following what was written on the board...
Those adjustments are to be made in the end

Still good information for those who are building. Thanks for sharing.