Page 1 of 1
What are the wire sizes for Molex connectors and Power
Posted: Oct 2nd, '19, 03:40
by Hmmm
I would like to know the wire sizes for the Molex connectors and the Power please. In the Build guide photo I see the 6 pin molex has a thicker Black plenum on some of the wires, why is that? Thanks
Re: What are the wire sizes for Molex connectors and Power
Posted: Oct 13th, '19, 12:46
by motjee
I used 2 shielded 2 wire speakercables, found it somewhere else on the forum.
I'm struggling right now figuring the correct orientation for the smd ic's. On my board it's not indicated.. as far as I can tell
Here is a picture of the cable
https://www.okaphone.nl/product/images/MC-102.jpg
Re: What are the wire sizes for Molex connectors and Power
Posted: Oct 21st, '19, 10:04
by jeroenbvo
Hi Motjee,
Look at this thread:
viewtopic.php?f=24&t=1165
Re: What are the wire sizes for Molex connectors and Power
Posted: Nov 16th, '19, 08:00
by Hmmm
motjee wrote:I used 2 shielded 2 wire speakercables, found it somewhere else on the forum.
I'm struggling right now figuring the correct orientation for the smd ic's. On my board it's not indicated.. as far as I can tell
Here is a picture of the cable
https://www.okaphone.nl/product/images/MC-102.jpg
There is a picture of the proper orientation forthe SMD ICs in the PDF Build guide for the Yocto2, page 20.
Re: What are the wire sizes for Molex connectors and Power
Posted: Dec 15th, '23, 02:32
by sparklesigh