Page 1 of 1

psu - not the exact voltage

Posted: Jan 4th, '19, 01:01
by pa47
please help, i measure between J10 pin1 and J10 pin8 only 4,92v. Is that a problem? all components are on the right place, ich checked that 200 times.
i get +15.09 and -15.03 that correct. but in the assemby guide is not tolerance for the +5volt rail.

thankx

Re: psu - not the exact voltage

Posted: Jan 4th, '19, 05:08
by gihaume
Just try like this. To reach another voltage you may try another regulator.

Re: psu - not the exact voltage

Posted: Jan 6th, '19, 23:46
by pa47
thank you for the answer.
i will try it. thanks

Re: psu - not the exact voltage

Posted: Jan 13th, '22, 16:54
by Djdu11
Hey guys!

What do u mean by « try another regulator »??

Just change the component??

For me -15,+15 are fine but I find 4,9 instead of 5V. What is the headroom for the 5Vrail?

R0ohm = jumper right??

Thx in advance

Re: psu - not the exact voltage

Posted: Nov 19th, '22, 13:39
by gihaume
Is there a problem ? Probably 4.9V is fine.