How do I test voices during building, and how do I check sec

• dnsmth9000

  Posts 13

  Joined: May 21st, '18, 19:25

  Jul 6th, '18, 21:06

  From the build guide:
  Yocto2 firmware allow you to test each voices during building process. A
  jumper on pins 1-2 of Test _mode header set the CPU in Voice test mode. In
  this mode a trig pulse is sent every second to all voices.
  
  Do all of the wires between IO and Main board need to be connected to do this?
  Where should I listen for the output?
  
  Also in the Nava assembly guide it at the end of each section it says something like 'check section power and voltages' before adding the ICs;
  How do I do this, what voltages and where do I test?
  
  Thanks

  • Quote