Yocto v2 test mode - R688

  • I just built the whole sequencer section. I literally went through the voices part list section by section. In each section just do resistors, then diodes, etc. Ended up working great. I did have to adjust TM2 to 200k and make the Cowbell mods mentioned in the Yocto1 "useful building tips" thread.

    For R688 I just put it on the opposite side of the PCB. You can also cut the piece on the socket but didn't seem necessary to me. You can also get a milled socket which don't seem to have that middle bridge on the socket. But it seemed simplest to just put on the "button side" of the PCB.
  • oh thanks that is helpful!