My finished Nava came home with me today for testing and was connected to the dinsync out of my MC-202.
It's in slave mode, but doesn't respond when I start the 202. The 202 clocks all my other Roland gear perfectly. Tried different cables.
Edit: I've also clocked other gear off the Nava in Master mode ok, with some of the same lag issues mentioned in other threads.
Could I have made an error in assembly? Or where could I start looking? Everything else works perfect.
Firmware 1.023
Dinsync slave problems
The DIN SYNC connector of the Nava is an output connector, not an input.
Thanks for the reply.
I had intended to use it as a slave. Am I required to rewire it to do so?
Edit: I'm slowly realising that it's not designed this way. I had assumed that since Yocto supports dinsync slave that Nava would too.
Is there any plan to introduce this or is it not supported due to the pinout?
I had intended to use it as a slave. Am I required to rewire it to do so?
Edit: I'm slowly realising that it's not designed this way. I had assumed that since Yocto supports dinsync slave that Nava would too.
Is there any plan to introduce this or is it not supported due to the pinout?
Hi.anotherlin wrote:The DIN SYNC connector of the Nava is an output connector, not an input.
Is there any chance to have Din Sync connector "converted" into an INPUT instead of an OUTPUT? Would really love to sync my Nava exactly like my Yocto (with Din Sync).
Thanks,
Flavio.