Page 1 of 1

Getting ready to start building!

Posted: Nov 27th, '15, 20:24
by 80sboy
Waiting for my final Mousers order to come today - used the latest BOM from here.

Any issues I should look out for? I have a good soldering station, going to pick up an oscilloscope soon - any mistakes etc to look out for in the build instructions?

I'm sure I'll be on here many more times with lots of questions!

thanks!

tom

Re: Getting ready to start building!

Posted: Nov 28th, '15, 08:48
by Maarten
Ordered THE right power supply? Cause I did not. Is also hard to get.
230VAC - 15VAC 1000mA

Cheers

Maarten

Re: Getting ready to start building!

Posted: Nov 29th, '15, 16:19
by SubStyler
in the germany area you can check this: http://www.henri.de/stromversorgung/ste ... ltbar.html

north america:
http://www.jameco.com/webapp/wcs/stores ... _100108_-1
you can also watch out for 16VAC or 18VAC as long as you'll get around 1000mA.


best,
Sub

Re: Getting ready to start building!

Posted: Jul 20th, '18, 12:30
by NadMk
SubStyler wrote:in the germany area you can check this: http://www.henri.de/stromversorgung/ste ... ltbar.html

north america:
http://www.jameco.com/webapp/wcs/stores ... _100108_-1
you can also watch out for 16VAC or 18VAC as long as you'll get around 1000mA.


best,
Sub

Hi Chris,
Can you send me a PM with your email contact?
Cheers..!!

.

Re: Getting ready to start building!

Posted: Jul 30th, '18, 12:08
by Lasuchis9
thanks a lot for the Jameco link! i really appreciate it a lot. i was also wondering if i might ask questions if you don't mind? thanks for everything anyway! Instant Pot Old Fashioned Sloppy Joes Hamburger