Waiting for my final Mousers order to come today - used the latest BOM from here.
Any issues I should look out for? I have a good soldering station, going to pick up an oscilloscope soon - any mistakes etc to look out for in the build instructions?
I'm sure I'll be on here many more times with lots of questions!
thanks!
tom
Getting ready to start building!
Ordered THE right power supply? Cause I did not. Is also hard to get.
230VAC - 15VAC 1000mA
Cheers
Maarten
230VAC - 15VAC 1000mA
Cheers
Maarten
in the germany area you can check this: http://www.henri.de/stromversorgung/ste ... ltbar.html
north america:
http://www.jameco.com/webapp/wcs/stores ... _100108_-1
you can also watch out for 16VAC or 18VAC as long as you'll get around 1000mA.
best,
Sub
north america:
http://www.jameco.com/webapp/wcs/stores ... _100108_-1
you can also watch out for 16VAC or 18VAC as long as you'll get around 1000mA.
best,
Sub
SubStyler wrote:in the germany area you can check this: http://www.henri.de/stromversorgung/ste ... ltbar.html
north america:
http://www.jameco.com/webapp/wcs/stores ... _100108_-1
you can also watch out for 16VAC or 18VAC as long as you'll get around 1000mA.
best,
Sub
Hi Chris,
Can you send me a PM with your email contact?
Cheers..!!
.
thanks a lot for the Jameco link! i really appreciate it a lot. i was also wondering if i might ask questions if you don't mind? thanks for everything anyway! Instant Pot Old Fashioned Sloppy Joes Hamburger