Finished yocto
Posted: May 2nd, '15, 01:00
hi I finished my yocto just thought I'd share some of the issues I encountered on the way
The burning the boot loader post is not Mac friendly , you must show contents to find the hardware folder
You may need to install a driver for the ARDNUINO board on a Mac
When I flashed the ATMEGA my yocto wouldn't go into sysex recieve mode , just all step lights lit holding down 1,3,5 did nothing , turned out I hadn't soldered in two of the sequencer chips
Had no cowbell or cymbal , the jumper cables between the main board and output board had broke connection
High hats were barely audible I had 470 ohm where 470k resistors should be and vice versa
Snare sounded tubby and clap wasn't right .... Bad op amp in the noise section
The burning the boot loader post is not Mac friendly , you must show contents to find the hardware folder
You may need to install a driver for the ARDNUINO board on a Mac
When I flashed the ATMEGA my yocto wouldn't go into sysex recieve mode , just all step lights lit holding down 1,3,5 did nothing , turned out I hadn't soldered in two of the sequencer chips
Had no cowbell or cymbal , the jumper cables between the main board and output board had broke connection
High hats were barely audible I had 470 ohm where 470k resistors should be and vice versa
Snare sounded tubby and clap wasn't right .... Bad op amp in the noise section