When I turn on the yocto the default tempo is very high (300 bpm? it looks like it plays 16 steps in ±1s).
Is this a default or is there something wrong with my yocto?
EDIT: is fixed now, my bad
SOLVED: Default tempo high?
-
Last edited by rv0 on May 17th, '15, 13:24, edited 1 time in total.Get the latest unofficial Yocto V1 firmware here.
Be sure to check the revised manual.
Leave your comments in this thread.
Hi rv0,
Mine runs at 120 bpm when I start it off. Maybe the program is faulty, but it would be weird. Did you notice other problems in the program? Did you try to initialize the eeprom again? I don't think that the initial bpm depends of the eeprom but it's worth the try (of course, if you want to keep your patterns in memory, you should not try this!)
Mine runs at 120 bpm when I start it off. Maybe the program is faulty, but it would be weird. Did you notice other problems in the program? Did you try to initialize the eeprom again? I don't think that the initial bpm depends of the eeprom but it's worth the try (of course, if you want to keep your patterns in memory, you should not try this!)
Hi BastienL
I still have the factory default patterns in it (init procedure after build was finished)
I still have the factory default patterns in it (init procedure after build was finished)
Get the latest unofficial Yocto V1 firmware here.
Be sure to check the revised manual.
Leave your comments in this thread.
Be sure to check the revised manual.
Leave your comments in this thread.
Dear Rv0,
Try to init again and have a look on the scale.
Best regards,
e-licktronic
Try to init again and have a look on the scale.
Best regards,
e-licktronic
Best regards,
e-licktronic
e-licktronic