Push encoder suddenly stop working after firmware update ?

Discuss Yocto construction and related issues
  • rqckmounted wrote:Hi all

    My Yocto v1 push encoder suddenly stop working, the tempo still works but not when I push it

    I’ve rarely used my yocto since I’ve built it and this function always used to worked properly but maybe after updating firmware that the problem arise ?

    Anyone here have this issue?

    Just dont feel like changing the pot if it a software problem

    Any help is appreciated

    Best regards,
    Does the encoder button push work if you go back to an earlier firmware version?
  • No I tryed to go back but it still does’nt work ?
  • In that case, it doesn't sound like you have a software problem. Check the connections on your encoder. You can try to reflow the solder joints to see if that helps.
  • Ok thanks for the tip !! I will check it out
  • thanks for the advice. I'll investigate it.