Page 1 of 1

Yocto handclap - only reverb, no clap? [SOLVED]

Posted: Jan 25th, '18, 15:06
by unclewoody
I'm troubleshooting my Yocto handclap. I see a lot of people have issues of not having the reverb tail - I have the opposite problem. My handclap is only the reverb noise, with no *clap*.

I've tried adjusting TM3 which seems to have little effect. I've also looked at the various pins on U23 and those seem to be outputting the correct signals.

Where in the circuit is the *clap* portion of the handclap so I have some idea of where to troubleshoot? Thanks!

Re: Yocto handclap - only reverb, no clap?

Posted: Jan 30th, '18, 19:59
by unclewoody
Just an update if others run into this problem....

Apparently, I had a bad BA6110. Replaced that and all is good now.

Re: Yocto handclap - only reverb, no clap?

Posted: Feb 12th, '18, 05:00
by helectromagneticus
Thanks for posting the solution! Too many online forums are full of comments like "I fixed it, nevermind" with no explanation of how it was done.