Roll function locking the whole system!

Discuss Yocto construction and related issues
  • hmm.. I haven't noticed this. I assume it isn't in expander mode - or it also does it there?
  • Hi again.
    I now did the following:
    • EEPROM initialisation - didn't solve the problem
      reinstalled via SysEx firmware version 1.0c - didn't solve the problem
    What can I do now?

    The shift button is working, because it triggered (together with start/stop) the EEPROM init function.
    While the Yocto is locked in the roll mode, I can switch through the modes with the upper rotary selector and nothing changes in behavior when pressing stop, shift or whatever button.
    When I move it into the "Track" position, then it stops playing (of course). Going back to "12 'o'clock" position (Pattern play) and pressing start again, the sequencer doesn't start anymore and instead the roll LED starts heavily blinking.

    Please - does anybody know what to do now?

    Thanks,
    Flavio.
  • Hi there!
    The problem was on R46 and R48 being "cold soldered": one leg of those resistors disconnected and so it was not working as expected anymore. In fact, only after re-soldering R46 the problem disappeared (I re-soldered R48 at first, not noticing R46 being wacky as well).

    BR,
    F.