e-licktronic Forum

Ciarany

Check your soldering in the sequencer section I could not upload sysex then I found I had not soldered in a couple of chips in the sequencer section , I built it ever so carefully but even so made that silly mistake ,

I had sounds missing turned out to be the ribbon cables had broken

Ciarany

hi I finished my yocto just thought I'd share some of the issues I encountered on the way The burning the boot loader post is not Mac friendly , you must show contents to find the hardware folder You may need to install a driver for the ARDNUINO board on a Mac When I flashed the ATMEGA my yocto woul...

Ciarany

hi I have done the snare revision in the tr808 manual My question is what sort of cap do I replace r127 with I have used a non polarised 10uf electrolytic Should I use a polarised one if so which direction does it go in ? My snare sounds better but now my clap is weird I have not yet changed r311 as...

Ciarany

Cowbell and cymbal fixed just broken ribbon cable

Clap good now

Hi hats are still reall quiet

Snare sounds woody and tubby

Ciarany

I sorted my issues out Here was my problem I am using a MAC Firstly the folders mentioned in how to burn the ATMEGA are in show contents, not my documents on a Mac I flashed the ATMEGA with the 16mhz boot loader and the ARDNUINO software confirmed it had completed but I couldn't get yocto into sysex...

Ciarany

Thanks I'll take a look , the noise section does work just doesn't seem present in the snare
I built very carefully triple checked everything , and all the parts added up at the end , but must have made mistakes somewhere , thanks for your tips

Ciarany

hi my yocto has no cowbell or cymbal sound anybody know where to start looking

Also the hi hats are really really quiet barely audible
The snare also doesn't sound right no noise element
The clap also isn't quite right and maraca doesn't work

The kik toms rim clave are all great on the upside

Ciarany

hi I'm having trouble getting my yoocto into sysex mode , i have followed the how to burn boot loader instructions i have burned boot loader yocto 16 mhz and aurdino says it has completed it when i plug in yocto holding 1 3 5 i just get all 16 steps lit i have seen other posts on here with people th...

Ciarany

cheers , my leds don't really have a flat side i can see but i can work it out form your post thanks

Ciarany

hi I don't understand how the LEDs are orientated , which goes to the flat side anode or cathode

Cheers Ciaran

Search found 16 matches

Re: My yocto is not working in many differnent ways... HELP

Finished yocto

808 manual snare revision questions

Re: No cowbell or cymbal sound at all

Re: can't load sysex

Re: No cowbell or cymbal sound at all

No cowbell or cymbal sound at all

can't load sysex [SOLVED]

Re: Which polarity goes to the flat side of LEDs

Which polarity goes to the flat side of LEDs