e-licktronic Forum

brock0791

Opened it up and I'm now getting 3.7v on the 5v lines coming off the power board and I believe it's the 5v that runs the sequencer. It appears as though the headsink slipped down on the regulator and bridged the 3 prongs causing a short. Going to rebuild the power section and go from there. Just a h...

brock0791

What are you referring to? The 4 trimpot calibration settings are all in the build guide? Cowbell usually needs a resistor mod to ge a high enough pitch. What else do you need?

brock0791

After a new unit working fine as it should for 3 months all of a sudden all 16 step lights are illuminated (none of the 6 led's for mute/roll time sig are on) and don't seem to work. Tried an eeprom init and still nothing in pattern mode. any ideas? When i turn it on it makes a loud noise like all s...

brock0791

Had no idea you could turn a trace overlay on the eagle on. Thanks for the tip

brock0791

I'm debugging a build for a friend and not getting any noise to the clap or snare. I think it's due to a lifted through hole at pin 5 (bottom left) of the noise op amp (not having an op amp in the board results in the same sound) Using DSL man's schematics i have continuity to R124 but not to R132 o...

brock0791

I'll just buy it on amazon since I'm in canada and don't want to wait but judging by that link I'll assume the UNO model works. Thanks again

brock0791

Thank you for this. Any recommendation as to which arduino board I should buy?

brock0791

Bom seems to be good now except I believe you should need 29 22k resistors instead of 28. Only issue with getting the half kits as they are now sold in is the fact that you have to program the 1284 microprocessor yourself and the build guide hasn't been updated with instructions on that process.

brock0791

Noise: x1
Accent: x3
Bassdrum: x2
Snaredrum: x1
Lowtom: x5
Middletom: x4
Hightom: x4
Rimshot: x1
Handclap: x4
Cowbell: x1
Cymbal: x1
Hihats: x2
Total: 29

brock0791

Build requires 29 4k7 resistors. Bom lists 28

Search found 17 matches

Re: Sequencer issue

Re: Where are the calibration instructions?

Sequencer issue

Re: Noise Issue

Noise Issue

Re: TUTO: How to burn Yocto v1.0 Bootloader with an Arduino

Re: TUTO: How to burn Yocto v1.0 Bootloader with an Arduino

Re: TUTO: How to get a Full Yocto v1.0 Kit

Re: TUTO: How to get a Full Yocto v1.0 Kit

Re: TUTO: How to get a Full Yocto v1.0 Kit