e-licktronic Forum

ikke

Probably using a DC wall wart. You need one with an AC output.

ikke

Happy customer over here after my Atmel/microcontroller got bricked and bought one from SubStyler!

My Yocto is running fine again!

ikke

Got one from SubStyler and I'm happy that my Yocto works again!

ikke

I still think it's the Atmel that is bad or not programmed properly. You're lucky as I'm in the same boat at the moment. My Yocto got bricked by some serious static discharge and got stuck. No response at all after playing well for months... I tried to flash it again with an Arduino and an AVR progr...

ikke

Great service you're offering!

ikke

Do we have to be on a list like when we wanted to purchase the Yocto??

ikke

Cool! When will it be available?

ikke

You can't measure them in circuit because they are both in paralel with each other and facing the opposite direction so you'll have lift the lead of each diode at one side to make a proper measurement.

I think that it's probably U18 that went bad or something.

ikke

Hey Jeremy, I think it has something to do with the R/C's on the powerlines and their tolerances. You could have a look at R165*, C85* for the 15V+ line and R164*,C84 on the 15V- line and see how big the input voltage and voltage drop is and compare them to for instance +/- B2. It also depends a bit...

ikke

I made a mistake concerning the resistor as a load... That applies to -15V rail.
Just start with the correct PSU and let's see what readings you get than.

viewtopic.php?f=16&t=373

Search found 104 matches

Re: Power supply no -15 Volt ground

Re: To all Yocto and Nava friends in Europe

Re: ATmega1284-P programmed ?

Re: +15 volt on +5 volt and visa versa mistake

Re: To all Yocto and Nava friends in Europe

Re: Nava

Re: Nava

Re: VR15 (Hi Tom Tune) does not do anything.

Re: Cymball voltage on U5 testing low by .5V

Re: Power Supply Issue