e-licktronic Forum

Iggy

Hi! I built it as a Newbie and I barely made it to the finish line. The soldering itself is doable once you get a knack for it, but unsoldering (once you have to) might be difficult with unleaded solder or without an unsoldering station (I think the infamous ZD 915 is a good choice). If you work ver...

Iggy

I finally got to the bottom of this problem: After I could afford an IR cam, the problem became evident as you can see (the BA6110 seems shorted). I recommend everyone who seriously suspects their build having a short circuit to do the same and IR image their boards if there are no visible traces of...

Iggy

Hey fellow builders! Today I ran in a serious problem (at least I think so) after finishing the ride/crash section. When I plug in the PSU cable and check the voltage control points, I measure about 5V at the ICs and about +15V at the square marked pins of the op amps. So far, so good - but at the r...

Iggy

Ha, I'm so relieved! Thanks! I completely overlooked that around two am local time

Iggy

Hey community, I started building my Nava 909 and successfully finished the PSU and noise section today. PSU seems to be working just fine, but I'm not sure about the noise: When I attach my oscilloscope for testing just a described at the end of the noise section building instructions , I measure a...

Iggy

Oh snap, now I know better. Thanks for the offer though!

Iggy

Hey Community! My Nava kit just arrived and I'm so excited to start the build! :o I'm waiting for my Mouser order though, and the longer I wait, the more parts start missing. At the moment, I need to replace: "559-FOXS160-20-LF FOXSLF/160-20 16MHz 20pF Fox Crystals" 1 1 Okt. 28, 2019 "...

Search found 7 matches

Re: Newbie Build

[SOLVED] Voltage Problem: -15V pins are only at -5V

Re: Noise section voltage too high?

[Solved] Noise section voltage too high?

Re: Nava v1.0 BOM [5/18/16 IMPORTANT BOM UPDATE]

Re: Nava v1.0 BOM [5/18/16 IMPORTANT BOM UPDATE]