e-licktronic Forum

JvR

Hi there, It seems that you have a EEprom issue. Try to tie Pin 7 of IC115 (EEprom) to GND it should solve your issue This is not the problem. Pins 1-2-3-4-7 are connected to the 0V of IC115. Pin 8 to + 5V and pin 5 is SDA and pin 6 is SCL. Only the Config Settings are not saved. Other settings lik...

JvR

Conjure wrote:Anyone? I tried flashing it all manually with my AVR and it defaults to "EXPANDER" on v1.028.

I have the same problem and cann't find the solution. So I need also helpers !!!

JvR

Replace VR4G$1 with a 150 or 200K pot. (Volume will be much louder !!) BUMP BUMP BUMP! Everything solved, except for the bass drum, the volume is still low, on individual outputs as well as on master out. This is strange cause in my other nava the bd volume is waaaay higher. Anynone? I'm quite despe...

JvR

JimAudio wrote:Does anyone know if this is possible or planned for a future firmware release?
Thanks!

I'm also waiting for this. A special software version can be made for Yocto and Nava Vincent ???
Thanks,

JvR

JvR

Hi there! I own a Yocto 2 already built by somebody else. I don't have clear information regarding the firmware update procedure. Can anybody guide me through all the necessary steps? Cheers The Nava update procedure (hold switches 1,3,5 when powering up) doesn't work with the Yocto 2 for whatever ...

JvR

Hi all, just completed my build and after a lot of troubleshooting my Nava is almost fully working. Several bad M5128s caused several headaches! So the last issue I have is there is no way to vary the open hihat accent. It is always full. I can not get a half lit led indicating less accent, the onl...

JvR

Thanks for the hex file.

Cheers Jos

JvR

Thank you but I need a .hex or .bin file because I programmed with a TL866 programmer.
Please upload hex file. Thanks

Cheers Jos

JvR

Another solution is to change the resitors R525 and R526 on the IO-Board near the Crash Jackconnector. - R525 change to 5K8 - R526 change to 4K7 The volume will be better and it's still to low you can make lower the resistors until 1K0. I had done the same also with another instruments when the volu...

JvR

Just for the record: The current code only sends Clock and start/stop. No midi note output is implemented. It's quite easy to implement, but there should also be a way to turn it off imho, and providing a decent mechanism for settings like this is more advanced. Yes this is the Output of MIDI Out. ...

Search found 10 matches

Re: New Nava - Firmware Issues (Hardware-related)

Re: New Nava - Firmware Issues (Hardware-related)

Re: No Kick Drum and strange accent behaviour on Hi-Tom.

Re: MIDI Transmit From Sequencer

Re: Official Yocto² Firmware

Re: Open hi hat Accent always on full

Re: Official Yocto² Firmware

Re: Official Yocto² Firmware

Re: NAVA 909 to sell

Re: Yocto midi out what does it do